www,黄片视频,男女啪啪啪三级毛片视频,在线毛片亚洲中文,欧美理论片一区二区三区

Pneumatic tire rims Solid tires and corresponding pneumatic tire rims are interchangeable. However, the loading and unloading of solid tire rims can only be completed with auxiliary tools (tooling) on the press. To ensure the safety and accuracy of the installation process, the following rules should be followed:

1. First, check the suitability of the tire and rim, that is, whether the specification and model of the tire to be installed are the same as those of the rim. The width of rims used by tires of the same specification is different, so it should be confirmed first during installation. Rim inspection includes whether the rim has defects and burrs. If there is burr, polish it first, otherwise it is easy to hang inside the tire hub, affecting the installation and use.

2. In order to ensure that the tire can be installed in place smoothly and reduce friction with the rim, during installation, the inner hub of the tire and the outer surface of the rim need to be sprayed and coated with lubricant. The lubricant can be commonly used soapy water, washing powder water, etc. If possible, special lubricant for the tire can be used, but common industrial lubricants such as grease can not be used, because they will swell the rubber and damage the tire.

Forklift solid tire price

3. When the tire is placed on the rim, the head shall be flat without deflection, or it will be difficult to install and swing from side to side during use. The rim must be installed in place, and the bolts must be tightened, otherwise the slip ring or the tire rim may be separated, causing danger.

4. According to the requirements of ETRTOEDI standard, tyres must be concentric when loaded on the vehicle. Different specification manufacturers and worn tires cannot be installed on the same vehicle or the same axle, and cannot be mixed with pneumatic tires, otherwise it is easy to cause personal injury and equipment accidents.